Sterling-scale XC880A Bedienungsanleitung PDF herunterladen (Seite 18)

XC880A OWNERS MANUAL

Prompt to Count: Enabling this function will cause the XC880A to prompt

the operator for an Average Piece Weight (APW) when

opening a part file which has no saved APW. See section 2.2.5

for details on APW prompting. If the operator chooses not to

enter or calculate the APW, the file will be opened in Weight

Mode only.

Prompt Setpoints: If enabled, the operator will be prompted for setpoint data

when opening a part file that has no stored setpoint mode. See

section 6.1 for details on setpoint setup.

3.6 User Password

The XC880A allows the entry of a user programmable password to protect

certain functions, or memory operations from unauthorized access. When shipped

from the factory, the XC880A will have no user password set. Follow the

procedures below to enter or change the user password.

3.6.1 Changing/Clearing The User Password

The user code may be changed or cleared in the following manner.

1. Press the ‘SHIFT’ key followed by the ‘P’ key.

The XC880A prompts to ‘CHANGE PASSWORD ?’ Press ‘1’

to continue or ‘0’ to cancel and jump to step 6..

2. The XC880A now prompts the user to enter the current

Password. The code being changed must be known to continue.

Enter the code followed by the ‘ENTER’ key. If the incorrect

code was entered, “INCORRECT CODE!’ will be displayed

momentarily and the user will against be prompted for the

correct code.

3. The XC880A prompts to ‘ENTER NEW CODE’. The user

may now enter the desired password of up to 16 alphanumeric

characters. Up to this point, the code change may be canceled

by pressing the ‘RESET’ key, which will cause the XC880A to

prompt for ‘CANCEL CHANGE?’. Pressing ‘1’ at this time

will cancel the operation and retain the previous code.

Pressing ‘0’ will again prompt for a new code.

4. Once the desired password has been entered, press the

‘ENTER’ key. The user is prompted to re-enter the password.

If both passwords match, the XC880A momentarily displays

“PASSWORD CHANGED” and returns to its previous state.

The new code is stored and becomes effective at this time.

5. If ‘NO’ was chosen in step 2, The XC880A prompts to

“CLEAR PASSWORD?”

a. Press ‘1’ or ‘Y’, and the operator is prompted to enter

the current password. If correct, the password is reset

and will not be prompted for.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 54 55

Keine Kommentare

Sterling-scale XC880A Bedienungsanleitung Seite 18